Durability, sustainability and cost analysis of the effect of SNF superplasticizers on locally produced concrete in Ghana
Abstract
Using conventional methods of concrete production to achieve expected results is challenging, hence the use of chemical admixtures which is also little researched in Ghana. The study conducted a concrete mix design for project construction, following significant challenges encountered in attaining the desired strength of 30MPa at a slump of S3 (100-150mm). To address the challenge, a concrete mix design was produced according to EN 206 standard mix design at the laboratory of the Council for Scientific and Industrial Research (CSIR)-Building and Road Research Institute (BRRI)-Ghana. A chemical admixture consisting of high-range water-lowering sulfonated naphthalene formaldehyde (SNF) was used in the design. Once the laboratory mix design was completed, the concrete mix proportions were adopted for field application. When employing 385kg/m3 of Portland cement, a water-to-cement ratio of 0.49, a water content of roughly 189kg/m3, and an admixture content of 3.28kg/m3, the laboratory mix design yielded a 28-day compressive strength of 37 MPa (5366 psi). After 28 days of curing, both the laboratory (37MPa) and field-prepared (31MPa) concretes met the minimum strength of 30MPa with the laboratory-controlled concrete exhibiting compressive strength results that were approximately 16% greater than those of the field-prepared concretes. The report revealed that the use of SNF resulted in 18% savings in cement thereby reducing carbon emissions and 5% savings in cost, urging a case for the use of chemical admixtures for structural and non-structural concrete components of the project for the sake of durability, sustainability and cost.
References
Adesina PA, Olutoge FA. Structural properties of sustainable concrete developed using rice husk ash and hydrated lime. Journal of Building Engineering. 2019; 25: 100804. doi: 10.1016/j.jobe.2019.100804
Assiamah S, Agyeman S, Adinkrah-Appiah K, et al. Utilization of sawdust ash as cement replacement for landcrete interlocking blocks production and mortarless construction. Case Studies in Construction Materials. 2022; 16: e00945. doi: 10.1016/j.cscm.2022.e00945
Aytekin B, Mardani-Aghabaglou A. Sustainable Materials: A Review of Recycled Concrete Aggregate Utilization as Pavement Material. Transportation Research Record: Journal of the Transportation Research Board. 2021; 2676(3): 468-491. doi: 10.1177/03611981211052026
Bediako M, Valentini L. Strength performance and life cycle assessment of high-volume low-grade kaolin clay pozzolan concrete: A Ghanaian scenario. Case Studies in Construction Materials. 2022; 17: e01679. doi: 10.1016/j.cscm.2022.e01679
Sirangi B, Prasad MLV. A low carbon cement (LC3) as a sustainable material in high strength concrete: green concrete. Materiales de Construcción. 2023; 73(352): e326. doi: 10.3989/mc.2023.355123
Bouzoubaâ N, Zhang MH, Malhotra VM. Superplasticized portland cement: production and compressive strength of mortars and concrete. Cement and Concrete Research. 28(12); 1783-1796. doi: 10.1016/S0008-8846(98)00154-9
Buertey JIT, Atsrim F, Offei, SW. An Examination of the Physio-mechanical Properties of Rock Lump and Aggregates in Three Leading Quarry Sites Near Accra. American Journal of Civil Engineering. 2016; 4(6): 264. doi: 10.11648/j.ajce.20160406.11
Buertey JIT, Offei SW, Adjei Kumi T, et al. Effect of aggregates minerology on the strength of concrete: Case study of three selected quarry products in Ghana. Journal of Civil Engineering and Construction Technology. 2018; 9(1): 1-10. doi: 10.5897/jcect2017.0472
Buertey JTI, Atsrim FK, Boateng K, et al. An Evaluation of the Causes, Impact and Perceptions about Abandoned Public Funded Projects in Ghana. Current Approaches in Engineering Research and Technology Vol 6. 2024; 94-126. doi: 10.9734/bpi/caert/v6/1273
Ghana Standard Authority. Building and Construction Materials-Composition, Specifications, and Conformity Criteria for Common Cement, GS 1118:16. Ghana Standard Authority; 2016.
European Committee for Standardization. Concrete Specification, Performance, Production and Conformity, the European Standard, BS EN. European Committee for Standardization; 2000.
El Gamal Safaa M, Bin Salman HM. Effect of addition of Sikament-R superplasticizer on the hydration characteristics of portland cement pastes. HBRC Journal. 2012; 8(2): 75-80. doi: 10.1016/j.hbrcj.2012.09.001
Flatt R, Schober I. Superplasticizers and the rheology of concrete. Understanding the Rheology of Concrete. 2012; 144-208. doi: 10.1533/9780857095282.2.144
Go SS, Chung CW, Struble LJ, et al. Pozzolanic activity of Hwangtoh clay. Construction and Building Materials. 2010; 24(12): 2638-2645. doi: 10.1016/j.conbuildmat.2010.04.061
Joshi R, Singh A, Resatoglu R, et al. Effect of elevated temperature on Portland Pozzolona cement based concrete using Sulphonated naphthalene formaldehyde and Polycarboxylic ether as superplasticizer. Materials Today: Proceedings. 2023. doi: 10.1016/j.matpr.2023.03.483
Kapelko A. The possibility of adjusting concrete mixtures' fluidity using superplasticizer SNF. Archives of Civil and Mechanical Engineering. 2006; 63(3): 37-53. doi: 10.1016/S1644-9665(12)60240-4
Kirkelund GM, Skevi L, Ottosen LM. Electrodialytically treated MSWI fly ash use in clay bricks. Construction and Building Materials. 2020; 254: 119286. doi: 10.1016/j.conbuildmat.2020.119286
Li H, Du H, Zeng S. Effects of water-reducing agents on the performance of low-carbon cementitious materials. Construction and Building Materials. 2020; 240: 117905. doi: 10.1016/j.conbuildmat.2020.117905
Mehta PK, Monteiro PJM. Concrete: Microstructure, Properties, and Materials. McGraw-Hill Education; 2017.
Mo Z, Han Y, Jiang L, et al. Strength properties and hydration of ultra-high performance concrete incorporating calcined clay and limestone with steam curing regimes. Case Studies in Construction Materials. 2022; 17: e01658. doi: 10.1016/j.cscm.2022.e01658
Neville AM. Properties of Concrete. Pearson Education; 2011.
Sakai E, Ishida A, Ohta A. New Trends in the Development of Chemical Admixtures in Japan. Journal of Advanced Concrete Technology. 2006; 4(2): 211-223. doi: 10.3151/jact.4.211
Sathyan D, Anand KB. Influence of superplasticizer family on the durability characteristics of fly ash incorporated cement concrete. Construction and Building Materials. 2019; 204: 864-874. doi: 10.1016/j.conbuildmat.2019.01.171
Šiler P, Kolářová I, Krátký J, et al. Influence of superplasticizers on the course of Portland cement hydration. Chemical Papers. 2014; 68(1). doi: 10.2478/s11696-013-0413-x
British Standards Institution. Specification for Aggregates from Natural Sources for Concrete, London. British Standards Institution; 1992.
American Society of Mechanical Engineers. Standard Specification for Concrete Aggregates. American Society of Mechanical Engineers; 2007.
European Committee for Standardization. Testing Fresh Concrete Part 2: Slump-Test, Pub. L. No. BS EN 12350-2. European Committee for Standardization; 2009.
European Committee for Standardization. Testing Hardened Concrete, Part 3: Compressive Strength of Test Specimen. European Committee for Standardization; 2009.
Tkaczewska E. Effect of the superplasticizer type on the properties of the fly ash blended cement. Construction and Building Materials. 2014; 70: 388-393. doi: 10.1016/j.conbuildmat.2014.07.096
Yu S, Du H, Sanjayan J. Aggregate-bed 3D concrete printing with cement paste binder. Cement and Concrete Research. 2020; 136: 106169. doi: 10.1016/j.cemconres.2020.106169
Wei J, Long WJ, Khayat KH, et al. Dynamical properties of environmental high-performance composites with calcined clay. Journal of Cleaner Production. 2022; 335: 130226. doi: 10.1016/j.jclepro.2021.130226
Yagubkin A, Shabanov D, Niyakovskii A, et al. Maximizing strength and durability in wood concrete (arbolite) via innovative additive control and consumption. Biomass Conversion and Biorefinery. 2024. doi: 10.1007/s13399-024-06071-6
Copyright (c) 2025 Joseph Ignatius Teye Buertey, Mark Bediako, Emmanuel Appiah-Kubi, Timothy Ametefe
This work is licensed under a Creative Commons Attribution 4.0 International License.
